For more information about interface notations, see the “Configuring Interfaces” chapter in the software configuration guide for this release. If you want to configure a specific stack member port, you must include the stack member number in the CLI command interface notation. Note We recommend using one CLI session when managing the switch stack. Therefore, it is possible to lose track of the session from which you entered commands. Commands you enter in one session are not displayed in the other sessions. Be careful with using multiple CLI sessions to the stack master. You can connect to the stack master through the console port of one or more stack members. You cannot manage stack members on an individual switch basis. You manage the switch stack and the stack member interfaces through the stack master. In this document, IP refers to IP version 4 (IPv4) unless there is a specific reference to IP version 6 (IPv6).

For task-oriented configuration steps, see the software configuration guide for this release.For more information on Cisco IOS Release 12.2, see the Cisco IOS Release 12.2 Command Summary.For information on the show platform commands, see Appendix C, “Catalyst 3750 Switch Show Platform Commands.”.For information on the debug commands, see Appendix B, “Catalyst 3750 Switch Debug Commands.”.

For information on the bootloader commands, see Appendix A, “Catalyst 3750 Switch Bootloader Commands.”.

For a complete description of the commands that support these features, see Chapter2, “Catalyst 3750 Switch Cisco IOS Commands”.

This chapter describes how to use the switch command-line interface (CLI) to configure software features. The Catalyst 3750 switch is supported by Cisco IOS software.

Cisco 3750 command reference